Downloading and installing relevant files

Currently only supporting Windows OS.

The below is optional. All software that is needed to be installed should be included within the project folder.

Windows

Software suite	Download link
KEVYILBOARD APT C2	https://github.com/RedBulletTooling/APT-KEYVIL
Arduino	https://downloads.arduino.cc/arduino-1.8.12-windows.exe
nRF Connect	https://www.nordicsemi.com/Software-and-tools/Development-Tools/nRF-Connect-for-desktop
nRF CLI	https://www.nordicsemi.com/Software-and-tools/Development-Tools/nRF-Command-Line-Tools/Download
FTDI drivers	https://www.ftdichip.com/Drivers/CDM/CDM21228_Setup.zip
SEGGER Driver 6.88b	https://www.segger.com/downloads/jlink/JLink_Windows_V688b.exe
Python	https://www.python.org/ftp/python/3.9.2/python-3.9.2-amd64.exe
West	pip3 install -U west
Cmake	https://github.com/Kitware/CMake/releases/download/v3.20.0/cmake-3.20.0-windows-x86_64.msi
Putty	https://the.earth.li/~sgtatham/putty/latest/w64/putty-64bit-0.74-installer.msi
Git	https://github.com/git-for-windows/git/releases/download/v2.34.1.windows.1/Git-2.34.1-64-bit.exe

Download the latest version, unless otherwise specified.

nRF Connect

After installing the nRF Connect suite, the following apps need to be installed via the suite;

• LTE Link Monitor(Optional)

• Programmer(Optional)

• Toolchain Manager

Inside the Toolchain Manager, you need to download the nRF Connect SDK 1.5.0. Do NOT install any other version, this will cause issues.

Reboot your system after installation of all the software. Ignoring this warning, will cause you a lot of wasted time.